Please use fresh gasoline. The fuel should be less than 30 days old, grade 87 octane, and free of water and dirt. It's best to use ethanol-free fuel. Your product is 4-cycle, so do not mix oil into the gas.
You will get efficient and thoughtful service from Senix.
Go through the cold start starting process. Remember not to engage the throttle while pulling the starter cord. If the tool still doesn't start after several pulls, depress and release the throttle trigger to release the choke, then pull the starter cord until the engine starts.
Refer to the product manual for full instructions.
Make sure that you are using fresh fuel that is less than 30 days out of the pump. Your product has a 4-cycle engine, so do not mix oil into the gas.
If your product has several hours of operation, you may need to clean or replace the air filter. This also applies to the fuel filter. If none of these work, please contact us at .
Make sure that you are using fresh fuel that is less than 30 days out of the pump. Your product has a 4-cycle engine so do not mix oil into the gas.
If your product has several hours of operation you may need to clean or replace the air filter. Same with fuel filter.
Are you interested in learning more about SENIX X2 outdoor equipment? Contact us today to secure an expert consultation!
If none of these work please contact us at
This is a common occurrence with most chain saws. After use, a chain saw is hot, and a slight pressure can build up in the oil reservoir. This could cause oil to seep out after shutting off the saw. Pressure can be released by loosening and re-tightening the bar oil filler cap. Using premium bar and chain oil will reduce the chance of this happening.
If you use regular motor oil in place of bar and chain oil, your chain saw may leak after shutting off. A good practice is to set your saw on something to absorb oil after each use.
The battery may not be secured in place. Make sure the battery is fully seated and the battery latch tab on the product is snapped into place.
Also, the battery may not be fully charged. Charge the battery according to the instructions included with your Senix Tools X5 Cordless battery charger.
A neglected lawn. A fallen oak. A neighbor’s hedge. With this much power, there’s no telling what task you’ll turn to. Whether you go with our gas, corded, or cordless options, rest assured the job will get done leaving you wondering…what’s next?
For more SENIX 20V batteryinformation, please contact us. We will provide professional answers.